How To Replace Oil Pressure Sensor Dodge Charger

June 02, 2021

One of the first things that people do when they have the low oil pressure light is to change out this sensor to see if that rectifies the problem. Search near the oil filter to find the switch.

2014 Dodge Charger Oil Pressure Sending Unit Location Youtube

Please narrow the Oil Pressure Sender Switch results by selecting the vehicle.

How to replace oil pressure sensor dodge charger. Related repairs may also be needed. Labor costs are estimated between 130 and 164 while parts are priced at 44. If your Chargers sensor has gone bad itll shoot a false low pressure reading to the ECM.

For a more accurate estimate based on your location use our Fair Price Estimator. Once the switch is located unplug the switch and use a socket to remove the switch from the engine block. The new sensor comes with thread sealant already in place so you just have to screw it in.

Get the front of the car off the ground and on some jack stands. Dodge Charger 2007-2016 6 Cyl 36L 8 Cyl 57L 8 Cyl 61L 8 Cyl 62L 8 Cyl. This range does not include taxes and fees and does not factor in your unique location.

Remove Oil Cap Take off the oil. 15mm socket wrench and open end wrench foot long extension for 38 drive 10mm socket cheater bar approx. The engine is started and oil pressure is checked then the vehicle is taken off the jack stands.

The installation should be reverse of removal. The defective oil pressure sensor is removed. Modern vehicles use an electric oil pressure sending unit.

The tools to use are. Youll want to use some electrical contact cleaner or WD40 on the harness connector to get the oil out so it can make a good connection with the replacement sensor. Test drive or operate the vehicle in accordance with the when monitored and set conditions with the scan tool read DTC.

I got a check engine light this morning with my 2013 Dodge Charger 36L with 53k miles I scanned the code and it is P0520 and I see that the oil pressure in the dashboard is not working fine so I figured I probably need to replace the oil pressure sensorsending unit. In the event the oil pump or solenoid are not functioning or out specification they must be replaced as an assembly. 66 Oil Pressure Switches found.

How to replace oil pressure sensor on a dodge charger. Sending Unit Oil Pressure. The vehicle is raised and supported on jack stands and tire is removed.

The new oil pressure sensor is installed. If youve gotten the 0520 error code it is time to replace your oil pressure sensor. The average cost for a Dodge Charger oil pressure sensor replacement is between 173 and 207.

If you are in doubt about this repair consider YourMechanic as oil pressure sensors can be replaced at your home or office by a certified professional. Oil Filter Change Dodge Charger 2006-2010 Find Oil Drain Locate the oil drain plug underneath the vehicle. 1 foot long car jack jack stands electrical tape First things first.

Replace the Oil Pressure Sensor turn the ignition on with the scan tool erase the DTC. Hello guys I need some advice. Find Oil Filter Locate the oil filter.

How To Change The Oil Pressure Sensor